EverFocus PARAGON 264x4-16 Instruction Manual page 113

 To let the router automatically assign an address:
 Set the Network Type to DHCP. Make sure to write down the IP address and the Gateway.
 Exit from the Menu to save settings.
To manually assign an address:
 Go to a computer connected on the same network as the DVR.
 Click on the Start button and choose Run.
o If using Windows Vista, choose Search instead.
 Type "command" and click on OK.
o In Vista, you will need to double-click on the "Command Prompt" file to open it..
 In the DOS prompt, type "ipconfig" and press Enter.
 The network information will be displayed on a screen similar to the one below.
o In Windows Vista, look for the information that says "IP v4".
 Take the values for Subnet Mask and Default Gateway and input them into the DVR; these
values should be exactly the same in both devices. However, you should change the last
number of the IP address. For example, if the IP address of the computer is 192.168.2.101, the
DVR's IP address should be 192.168.002.050.
 To access the DVR from a computer simply open Internet Explorer and in the address bar type:
http:// (IP address of the DVR)
Note: The DVR's IP address will only work at the location of the DVR. To connect from a

different location over the Internet, see below.
To set DVR for Internet Connection through router
107