Messages; Midi Ccs - M-Audio code25 User Manual

Messages

MIDI CCs

You can assign the sustain pedal to send a MIDI CC message when you press it.
To assign a MIDI CC to the volume pedal:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the volume pedal. VOL will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show VOL
and a number for the type of message it sends.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a MIDI CC number
(001–127).
5. Press the Data 2 key. The display will show DATA2 for 1 second and then show VOL and
the value it will send at its minimum position.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (001–127).
7. Press the Data 3 key. The display will show DATA3 for 1 second and then show VOL and
the value it will send at its maximum position.
8. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (001–127).
9. Press the Enter key. The volume pedal is now set to send the assigned MIDI CC, and you
will exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
Tip: You can reverse the direction (polarity) of the volume pedal so that its lowest position
sends its maximum value and vice versa. To do this, enter the desired maximum value in
Step 5 and the desired minimum value in Step 7.
95