Midi Cc Value Increment/Decrement - M-Audio code25 User Manual

MIDI CC Value Increment/Decrement

You can set a pad to increment/decrement a MIDI CC value by 1 each time you press it. After
it reaches its highest or lowest value, it will "wrap around" and start again at its lowest or
highest value, respectively. In other words, pressing the pad causes the value to cycle through
its entire range by increments of 1.
Important: Each pad with this type of assignment is independent of the others. If you set one
pad to increment a value and another pad to decrement the same value, they will each be
sending different values, not resuming where the other pad left off.
For example, pressing an "increment" pad would cause a MIDI CC value to become 1, 2, 3,
etc., but pressing a "decrement" pad for the same MIDI CC would cause it to become 127,
126, 125, etc.
To assign a pad to increment/decrement a MIDI CC value:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the desired pad. The pad's number will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show the
pad's number (P__)) and a number for the type of message it sends.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter 154 (to increment a
MIDI CC value) or 153 (to decrement a MIDI CC value).
5. Press the Data 1 key. The display will show DATA1 for 1 second and then show the pad's
number (P__) and the MIDI CC value it will increment/decrement.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (000–127).
7. Press the Data 2 key. The display will show DATA2 for 1 second and then show the pad's
number (P__) and the lowest value it will send.
8. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (000–127).
9. Press the Data 3 key. The display will show DATA3 for 1 second and then show the pad's
number (P__) and the highest value it will send.
10. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (000–127).
11. Press the Enter key. The pad is now set to increment/decrement the assigned MIDI CC
value, and you will exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
74