Midi Notes - M-Audio code25 User Manual

MIDI Notes

You can assign the buttons to send MIDI note numbers.
The buttons must be in MIDI Mode to do this (see
To assign a MIDI note to a button:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the desired button. The button's number will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show the
button's number (B__) and a number for the type of message it sends.
4. Use the numeric keys (0–9) to enter 147 (if the display does not already show it). This sets
the button to send MIDI note messages.
5. Press the Data 1 key. The display will show DATA1 for 1 second and then show the
button's number (B__) and a number for the MIDI note.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired note
number (001–127).
7. Repeat Steps 5–6 but using the Data 2 key. This will determine the Note Off velocity.
8. Repeat Steps 5–6 but using the Data 3 key. This will determine the Note On velocity.
9. Press the Enter key. The button is now set to send the assigned note, and you will exit
Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
Tip: You can assign a button to send a Note On message when it is pressed once and send a
Note Off message when it is pressed a second time. To do this, follow the steps above, but
enter 148 (instead of 147) in Step 4.
Modes > MIDI Mode).
54