Midi Notes - M-Audio code25 User Manual

MIDI Notes

You can assign the sustain pedal to send a MIDI note number when you press it.
To assign a MIDI note to the sustain pedal:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the sustain pedal. SUS will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show SUS
and a number for the type of message it sends.
4. Use the numeric keys (0–9) to enter 147 (if the display does not already show it). This sets
the sustain pedal to send MIDI note messages.
5. Press the Data 1 key. The display will show DATA1 for 1 second and then show SUS and
a number for the MIDI note.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired note
number (001–127).
7. Repeat Steps 5–6 but using the Data 2 key. This will determine the Note On velocity.
8. Repeat Steps 5–6 but using the Data 3 key. This will determine the Note Off velocity.
9. Press the Enter key. The sustain pedal is now set to send the assigned note, and you will
exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
Tip: You can assign a button to send a Note On message when it is pressed once and send a
Note Off message when it is pressed a second time. To do this, follow the steps above, but
enter 148 (instead of 147) in Step 4.
88