Messages; Midi Ccs - M-Audio code25 User Manual

Messages

MIDI CCs

You can assign the encoders to send MIDI CC messages when you turn them.
The encoders must be in MIDI Mode to do this (see
To assign a MIDI CC to an encoder:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Move the desired encoder. The encoder's number will appear in the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show the
encoder's number (E__) and a number for the type of message it sends.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a MIDI CC number
(001–127).
5. Press the Data 2 key. The display will show DATA2 for 1 second and then show the
encoder's number (E__) and the minimum value it will send.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (001–127).
7. Press the Data 3 key. The display will show DATA3 for 1 second and then show the
encoder's number (E__) and the maximum value it will send.
8. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (001–127).
9. Press the Enter key. The encoder is now set to send the assigned MIDI CC, and you will
exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
Tip: You can reverse the direction (polarity) of the encoder so that turning it clockwise
decreases the value and turning it counterclockwise increases it. To do this, enter the
desired maximum value in Step 5 and the desired minimum value in Step 7.
Modes > MIDI Mode).
61