Messages; Midi Ccs - M-Audio code25 User Manual

Messages

MIDI CCs

You can assign the wheels to send MIDI CC messages when you move them.
To assign a MIDI CC to a wheel:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Move the desired wheel. PW (pitch-bend wheel) or MW (modulation wheel) will appear in
the display.
3. Press the Ctrl Assign key. The display will show ASGN for 1 second and then show PW
or MW and a number for the type of message it sends.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a MIDI CC number
(001–127).
5. Press the Data 2 key. The display will show DATA2 for 1 second and then show PW or
MW and the value it will send at its minimum position.
6. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (001–127).
7. Press the Data 3 key. The display will show DATA3 for 1 second and then show PW or
MW and the value it will send at its maximum position.
8. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter a value (001–127).
9. Press the Enter key. The wheel is now set to send the assigned MIDI CC, and you will exit
Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
Tip: You can reverse the direction (polarity) of the wheel so that its lowest position sends
its maximum value and vice versa. To do this, enter the desired maximum value in Step 5
and the desired minimum value in Step 7.
Note: For the pitch-bend wheel, the minimum and maximum positions will determine its
entire range, not the range from its center position to its minimum or maximum positions.
85