Onkyo TX-NR1008 Instruction Manual page 85

Tip
• If you cannot access the database, a message "Cannot
connect to database." will appear. Press ENTER to
return to the previous step.
• If the brand name is not found, use r to select "Not
Listed", and then press ENTER.
The following screen appears.
8–1. Remote Mode Setup
Category
Brand
Model
Skip
Search by model number (via network)
8
Use q/w to select "Search by model number
(via network)", and then press ENTER.
The model number input panel appears.
When you do NOT have a network connection
or if you are not sure about the exact model,
select "Skip", and then press ENTER.
If you select "Skip", you will go to step 11.
9
Enter the model in a similar manner as in the
case of the brand name (step 6).
Tip
• After entering the 3rd character, press ENTER to start
searching.
• You cannot enter a space character.
10
Use q/w to select the model, and then press
ENTER.
If the model is not found, use r to select "Not
Listed", and then press
After searching is completed, a message for
remote control code transfer will appear.
8–1. Remote Mode Setup
Category
Brand
Model
Now we are ready to transfer data to the remote.
Please hold the remote so that it is facing the receiver.
Use ENTER button of your remote to activate "OK".
Ready?
OK
11
While pointing the remote controller at the AV
receiver's remote control sensor, press ENTER.
Remote control sensor (Transmitter)
Incoming sensor
15° off center
(Left/Right/Up/Down)
TV
TV
Sonic
(Option)
.
ENTER
TV
TV
XXXXX
xxxxx
15
15
Approx.
16ft. (5 m)
12
When you searched for the model, a message
"Successful" will appear. Now the transfer is
successful!
Go to step 15.
When you did NOT search for the model, the
following screen appears.
Push any key (except for arrow buttons and
ENTER) to see if the component responds.
8–1. Remote Mode Setup
Category
Brand
Code
1. Push some key to see if the TV responds.
(except Arrow and Enter.)
2. Choose "Works" or "Doesn't work".
*1
Works
Doesn't work (Retry)
*1 When category other than TV have been selected,
the content is different.
*2 Asterisks in [***/***] mean the order of the candi-
date code and the total number of the codes for the
brand.
13
If you can control component, press
RECEIVER, use q/w to select "Works", and
then press ENTER.
8–1. Remote Mode Setup
Category
Brand
Code
Now we are ready to transfer data to the remote.
Please hold the remote so that it is facing the receiver.
Use ENTER button of your remote to activate "OK".
Ready?
OK
If you cannot control component, press
RECEIVER, use q/w to select "Doesn't work
(Retry)" and press ENTER.
The next code appears. Repeat from step 11.
14
Press ENTER to transfer the determined code.
Remote control sensor (Transmitter)
Incoming sensor
15° off center
(Left/Right/Up/Down)
15
Press ENTER.
You'll return to the category selection menu.
Press SETUP to end the remote mode setup.
TV
TV
XXXXX
xxxxx[***/***]
*2
TV
TV
XXXXX
xxxxx[***/***]
15
15
Approx.
16ft. (5 m)
En
85