Connecting Antenna; Connecting The Power Cord - Onkyo TX-NR1008 Instruction Manual

Connecting Antenna

This section explains how to connect the supplied indoor FM antenna and AM loop antenna.
The AV receiver won't pick up any radio signals without any antenna connected, so you must connect the antenna to use
the tuner.
(North American and
Taiwan models)
Insert the plug fully
into the jack.
Thumbtacks, etc.
Note
• Once your AV receiver is ready for use, you'll need to tune into a radio station and position the antenna to achieve the best possible
reception.
• Keep the AM loop antenna as far away as possible from your AV receiver, TV, speaker cables, and power cords.
Tip
• If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available outdoor FM antenna instead.
• If you cannot achieve good reception with the supplied indoor AM loop antenna, try using it with a commercially available outdoor AM
antenna.

Connecting the Power Cord

Note
• Before connecting the power cord, connect all of your speak-
ers and AV components.
• Turning on the AV receiver may cause a momentary power surge
that might interfere with other electrical equipment on the same
circuit. If this is a problem, plug the AV receiver into a different
branch circuit.
• Do not use a power cord other than the one supplied with the AV
receiver. The supplied power cord is designed exclusively for
use with the AV receiver and should not be used with any other
equipment.
• Never disconnect the power cord from the AV receiver while the
other end is still plugged into a wall outlet. Doing so may cause
an electric shock. Always disconnect the power cord from the
wall outlet first, and then the AV receiver.
(European and Asian
models)
Insert the plug fully
into the jack.
Indoor FM antenna (supplied)
Caution
• Be careful that you don't injure yourself when
using thumbtacks.
Push. Insert wire.
Assembling the AM loop antenna.
AM loop antenna (supplied)
Step 1:
Connect the supplied power cord to the AV receiver's
AC INLET.
Step 2:
Plug the power cord into an AC wall outlet.
Release.
To AC wall outlet
21
En