Error Messages - Onkyo TX-NR1008 Instruction Manual

4
If you use a powered subwoofer(s), adjust the sub-
woofer volume level to 75dB.
Test tones are played through the subwoofer. Use the
volume control on the subwoofer.
Note
• If your subwoofer does not have a volume control, disre-
gard the level displayed and press ENTER to proceed to
the next step.
• If you set the subwoofer's volume control to its maximum
and the displayed level is lower than 75 dB, leave the sub-
woofer's volume control at its maximum and press
ENTER to proceed to the next step.
5
Press ENTER.
Audyssey MultEQ
Setup starts.
Test tones are played through each speaker as
Audyssey MultEQ Room Correction and Speaker
Setup runs. This process takes a few minutes. Please
refrain from talking during measurements and do
not stand between speakers and the microphone.
Do not disconnect the speaker setup microphone
during Audyssey MultEQ Room Correction and
Speaker Setup, unless you want to cancel the setup.
6
Place the setup microphone at the next position,
and then press ENTER.
Audyssey MultEQ performs more measurements.
This takes a few minutes.
7
When prompted, repeat step 6.
8
Use q/w to select an option, and then press
ENTER.
MultEQ: Auto Setup
Subwoofer
Front
Center
Surround
Front Wide
Front High
Surr Back
Surr Back Ch
Save
Cancel
The options are:
Save:
Save the calculated settings and exit
Audyssey MultEQ Room Correction and
Speaker Setup.
Cancel:
Cancel Audyssey MultEQ Room Correction
and Speaker Setup.
Note
• You can view the calculated settings for the speaker con-
figuration, speaker distances, and speaker levels by using
e/r.
9
Disconnect the speaker setup microphone.
En
30
® Room Correction and Speaker
- - Review Speaker Configuration - -
Yes
40Hz
TV
40Hz
100Hz
None
100Hz
120Hz
2ch
Note
• When Audyssey MultEQ Room Correction and Speaker Setup is
complete, the "Equalizer" will be set to "Audyssey"
The Audyssey indicator will light
• You can cancel Audyssey MultEQ Room Correction and
Speaker Setup at any point in this procedure simply by discon-
necting the setup microphone.
• Do not connect or disconnect any speakers during
Audyssey MultEQ Room Correction and Speaker Setup.
• If the AV receiver is muted, it will be unmuted automatically
when Audyssey MultEQ Room Correction and Speaker Setup
starts.
• Changes to the room after Audyssey MultEQ Room Correction
and Speaker Setup requires you run Audyssey MultEQ Room
Correction and Speaker Setup again, as room EQ characteristics
may have changed.

Error Messages

While Audyssey MultEQ Room Correction and Speaker
Setup is in progress, one of the error messages below may
appear.
MultEQ: Auto Setup
Ambient noise is too high.
Retry
Cancel
Error message
The options are:
Retry:
Try again.
Cancel:
Cancel Audyssey MultEQ Room Correction and
Speaker Setup.
• Ambient noise is too high.
The background noise is too loud. Remove the source of
the noise and try again.
• Speaker Matching Error!
The number of speakers detected was different from
that of the first measurement. Check the speaker con-
nection.
• Writing Error!
This message appears if saving fails. Try saving again.
If this message appears after 2 or 3 attempts, contact
your Onkyo dealer.
• Speaker Detect Error
This message appears if a speaker is not detected. "No"
means that no speaker was detected.
Tip
• See "Speaker Configuration" for appropriate settings
(➔ 49).
(➔ 9).
(➔ 13).