Supplied Accessories; Using The Remote Controller; Declaration Of Conformity - Onkyo TX-NR1008 Instruction Manual

For British models
Replacement and mounting of an AC plug on the power
supply cord of this unit should be performed only by qual-
ified service personnel.
IMPORTANT
The wires in the mains lead are coloured in accordance
with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this appa-
ratus may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured
black.
The wire which is coloured brown must be connected to
the terminal which is marked with the letter L or coloured
red.
IMPORTANT
The plug is fitted with an appropriate fuse. If the fuse
needs to be replaced, the replacement fuse must approved
by ASTA or BSI to BS1362 and have the same ampere rat-
ing as that indicated on the plug. Check for the ASTA
mark or the BSI mark on the body of the fuse.
If the power cord's plug is not suitable for your socket out-
lets, cut it off and fit a suitable plug. Fit a suitable fuse in
the plug.
For European Models

Declaration of Conformity

We, ONKYO EUROPE
ELECTRONICS GmbH
LIEGNITZERSTRASSE 6,
82194 GROEBENZELL,
GERMANY
declare in own responsibility, that the ONKYO product
described in this instruction manual is in compliance with the
corresponding technical standards such as EN60065,
EN55013, EN55020 and EN61000-3-2, -3-3.
GROEBENZELL, GERMANY
ONKYO EUROPE ELECTRONICS GmbH
En
4

Supplied Accessories

Make sure you have the following accessories:
Indoor FM antenna
AM loop antenna
Power cord
Speaker cable labels
Speaker setup microphone
Remote controller and two batteries (AA/R6)
(Note for China: The battery for the remote controller is not sup-
plied for this unit.)
* In catalogs and on packaging, the letter at the end of the prod-
uct name indicates the color. Specifications and operations are
the same regardless of color.

Using the Remote Controller

Installing the Batteries
Note
• If the remote controller
doesn't work reliably, try
replacing the batteries.
• Don't mix new and old
batteries or different
types of batteries.
• If you intend not to use
the remote controller for
a long time, remove the
batteries to prevent dam-
age from leakage or corrosion.
• Remove expired batteries as soon as possible to prevent damage
from leakage or corrosion.
Aiming the Remote Controller
To use the remote controller, point it at the AV receiver's
remote control sensor, as shown below.
Transmission
K. MIYAGI
Received
Incoming sensor
(➔ 21)
(➔ 21)
(➔ 21)
(➔ 13)
(➔ 29)
Batteries (AA/R6)
Remote control sensor
Approx. 16 ft. (5 m)
Transmitter
15
15
Approx. 16 ft. (5 m)
AV receiver
AV receiver