Cleaning; Washing The Machine; Storage - Toro 07383 Operator's Manual

Cleaning

Washing the Machine

The machine should be washed as needed. Use water alone
or with a mild detergent. A rag may be used when washing
the machine, however the hood will loose some of its luster.
Important: Do not use power washing equipment to
wash the machine. Power washing equipment may
damage the electrical system, loosen important decals,
or wash away necessary grease at friction points. Avoid
excessive use of water near the control panel, engine,
and battery.
Important: Do not wash the machine with the engine
running. Washing the machine with the engine running
may result in internal engine damage.

Storage

1. Position the machine on a level surface, set the parking
brake, stop the engine, and remove the ignition key.
2. Clean dirt and grime from the entire machine, including
the outside of the engine cylinder head fins and blower
housing.
Important: You can wash the machine with mild
detergent and water. Do not use high pressure
water to wash the machine. Pressure washing
may damage the electrical system or wash away
necessary grease at friction points. Avoid excessive
use of water, especially near the control panel,
lights, engine, and the battery.
3. Inspect the brakes; refer to Checking the Brake-fluid
Level (page 25).
4. Service the air cleaner; refer to Servicing the Air
Cleaner (page 42).
5. Seal the air cleaner inlet and the exhaust outlet with
weatherproof tape.
6. Grease the machine; refer to Greasing the Bearings and
Bushings (page 40).
7. Change the engine oil; refer to Changing the Engine
Oil and Filter (page 43).
8. Flush the fuel tank with fresh, clean diesel fuel.
9. Secure all fuel system fittings.
10. Check the tire pressure; refer to Checking the Tire
Pressure (page 25).
11. Check anti freeze protection and add a 50/50 solution
of water and anti freeze as needed for expected
minimum temperature in your area.
12. Remove the battery from the chassis, check the
electrolyte level, and charge it fully; refer to Servicing
the Battery (page 46).
Note: Do not connect the battery cables to the battery
posts during storage.
Important: The battery must be fully charged to
prevent it from freezing and being damaged at
temperatures below 0° C (32° F). A fully charged
battery maintains its charge for about 50 days
at temperatures lower than 4° C (40° F). If the
temperatures will be above 4° C (40° F), check the
water level in the battery and charge it every 30
days.
13. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
14. Paint all scratched or bare metal surfaces.
Paint is available from your Authorized Toro Service
Dealer.
15. Store the machine in a clean, dry garage or storage area.
16. Cover the machine to protect it and keep it clean.
57