Electrical System
Maintenance
Servicing the Fuses
The fuses for the electrical system are located under the
center of the dash panel (Figure 49 and Figure 50).
Figure 49
1. Fuses
Figure 50
1. Power outlet—10A
2. Switched power—10A
3. Fuel pump, supervisor
switch—10A
4. Horn, power point—15A
5. Lights, brake—15A
6. Hazard—10A
7. 4WD, Transmission—10A
Jump Starting the Machine
WARNING
Jump starting can be dangerous. To avoid personal
injury or damage to electrical components in
machine, observe the following warnings:
• Never jump start with a voltage source greater
than 15 volts DC This will damage the electrical
system.
• Never attempt to jump start a discharged battery
that is frozen. It could rupture or explode during
jump starting.
• Observe all battery warnings while jump starting
your machine.
• Be sure your machine is not touching the jump
start machine.
• Connecting cables to the wrong post could
result in personal injury and/or damage to the
electrical system.
1. Squeeze the battery cover to release the tabs from
battery base, and remove the battery cover from the
battery base (Figure 51).
1. Battery cover
2. Connect a jumper cable between the positive posts of
the 2 batteries (Figure 52). The positive post may be
identified by a + sign on top of the battery cover.
3. Connect one end of the other jumper cable to the
negative terminal of the battery in the other machine.
Note: The negative terminal has NEG on the battery
cover.
Note: Do not connect the other end of the jumper cable to the ne
45
Figure 51