Premaintenance Procedures; Using The Bed Support - Toro 07383 Operator's Manual

Premaintenance Procedures

Many of the subjects covered in this maintenance section require raising and lowering the bed. The following precautions must
be taken or serious injury or death could result.
WARNING
Before servicing or making adjustments to the machine, stop engine, set parking brake, and remove
the key from the ignition switch. Remove any load material from the bed or other attachment before
working under a raised bed. Never work under a raised bed without positioning the safety support on a
fully extended cylinder rod.

Using the Bed Support

Important: Always install or remove the bed support
from the outside of the bed.
1. Raise the bed until the lift cylinders are fully extended.
2. Remove the bed support from the storage brackets on
back of the ROPS panel (Figure 31).
Figure 31
1. Bed support
3. Push the bed support onto the cylinder rod, making
sure that the support end tabs rest on the end of
cylinder barrel, and on the cylinder rod end (Figure 32).
1. Bed support
2. Cylinder barrel
4. Remove the bed support from the cylinder and insert it
into the brackets on the back of the ROPS panel.
CAUTION
Do not try to lower bed with bed safety
support on cylinder.
36
Figure 32
3. Bed