Adjusting The Parking Brake; Cleaning; Washing The Vehicle - Toro 07287TC Operator's Manual

Adjusting the Parking Brake

Check the parking brake adjustment every 200
hours.
1. Pry the rubber cover off of the parking brake.
2. Loosen the set screw securing the knob to the
parking brake lever (Figure 47).
Figure 47
1. Parking brake lever
2. Knob
3. Rotate the knob until a force of 30-35 lb
(133-156 N) is required to actuate the lever.
4. Tighten the set screw and install the rubber
cover.

Cleaning

Washing the Vehicle

The vehicle should be washed as needed. Use
water alone or with a mild detergent. A rag may
be used, however the hood will loose some of its
luster.
Important: Do not use high pressure water
when washing the vehicle. It may damage the
electrical system, loosen important decals, or
wash away necessary grease at friction points.
Avoid excessive use of water, especially near
the control panel, motor, and batteries.
3. Set screw
38