Figure 15
1. Tire center line-back
2. Tire center line-front
3. Axle center line
2. If the measurement does not fall within the
specified range (refer to the dimensions and
parameters at the beginning of this procedure),
loosen the jam nuts at both ends of the tie
rods (Figure 16).
Figure 16
1. Jam nut
3. Rotate both tie rods to move the front of the
tire inward or outward.
4. Tighten the tie rod jam nuts when the
adjustment is correct.
5. Ensure that there is full travel of the steering
wheel in both directions.
4. Fixture
5. Axle center line distance
6. 6 inches (15 cm) ruler
2. Tie rod
Step
12
Reading the Manual and
Viewing the Safety Video
Parts needed for this step:
1
Operator's Manual
1
Parts Catalog
1
Safety Video
1
Registration Card
1
Predelivery Inspection Form
2
Key
Procedure
• Read the Operator's Manual.
• View the safety video.
• Fill out the registration card.
• Complete the Predelivery Inspection Form.
19