Installing The Cargo Box; Checking The Tire Pressure - Toro 07287TC Operator's Manual

11. Coat the battery terminals with Toro battery
terminal protector.
12. Ensure that the rubber boots on each battery
cable are securely seated over the battery
terminals.
Step
8

Installing the Cargo Box

Parts needed for this step:
1 Cargo box
1 Right-hand pivot bracket
1 Left-hand pivot bracket
4
Flange head screw (3/8 x 1 inch)
1 Bolt (5/16 x 3/4 inch)
1
Flange nut (5/16 inch)
Procedure
1. Position the cargo box onto the frame. The
cargo box must lay flat and be centered.
2. Mount the left hand pivot bracket to the left
rear corner of the frame with 2 flange head
screws (3/8 x 1 inch). Torque the screws to 16
ft-lb (22 N⋅m). Position the bracket as shown
in Figure 8.
3. Slide the cargo box mounting hole onto the
pivot bracket (Figure 12).
Figure 12
1. Cargo box
2. Pivot bracket
3. Cargo box mounting hole
4. Insert the right hand pivot bracket into the
mounting hole in the cargo box and then
mount it to the frame. Torque the screws to
16 ft-lb (22 N⋅m).
5. Have another person help to raise the cargo
box.
6. Loosen the bolt securing the prop rod clip to
the frame until you can slide the J-hook end of
the prop rod under the clip (Figure 13).
Figure 13
1. Prop rod
2. Prop rod clip
7. Tighten the bolt and secure the other side of
the clip with a new bolt (5/16 x 3/4 inch)
(Figure 13).
8. Lower the cargo box.
Step
9

Checking the Tire Pressure

No Parts Required
Procedure
Check the tire pressure every 8 hours or daily to
ensure proper levels.
The air pressure range in the front and rear tires
is 8-22 psi (55-152 kPa).
The air pressure needed is determined by the
payload carried. Lower air pressure will provide
less compaction, a smoother ride, and fewer tire
marks. Lower pressure should not be used for
heavy payloads at high speeds.
17
3. Bolt (5/16 x 3/4 inch)