Replacing The Fuses; Replacing The Headlights - Toro 07287TC Operator's Manual

5. Remove the battery retainers located between
the batteries.
6. Remove all of the batteries and recycle them
according to your local codes.
7. Install new batteries in the places vacated by
the old batteries
Note: Pay attention to the battery polarity
when installing the new batteries (Figure 38).
8. Install the battery retainers and torque the nuts
to 150 to 200 in-lb (17 to 22 N⋅m).
9. Connect the batteries together with the
battery cables removed previously, as shown
in Figure 38.
10. Connect the long, red, main positive lead
between the bank of batteries and the vehicle
(Figure 38).
11. Connect the long, black, main negative lead
between the bank of batteries and the vehicle
(Figure 38).
12. Torque the nuts securing all battery cables to
120 to 180 inch-lb (13.5 to 21 N⋅m).
13. Coat the battery terminals with Toro battery
terminal protector.
14. Ensure that the rubber boots on each battery
cable are securely seated over the battery
terminals.
Storing the Batteries
Charge the batteries fully before placing the
vehicle into storage. Plug the charger into a wall
outlet while the vehicle and batteries are in storage.
Leave the charger plugged into a wall outlet and
charging receptacle during storage to ensure that
the batteries stay charged and do not freeze;
otherwise, charge the batteries at least once every
3 months.

Replacing the Fuses

There are 3 fuses in the electrical system. They are
located beneath the bed in a box on the right hand
side of the frame (Figure 39).
Ignition System
Lights
Power Point
10 amp.
10 amp.
10 amp. (15 amp. max.)
34
Figure 39
1. Vehicle fuse

Replacing the Headlights

Specification: Toro #104-7312, 28 volt
Note: The headlights are wired in series;
therefore, when one headlight burns out, neither
will illuminate. If possible, change both headlights
at the same time.
1. Set the parking brake, turn the vehicle off, and
remove the key.
2. Reach beneath the dash and push the headlight
out of the hood.
3. Remove the screws attaching the wire harness
to the headlight.
4. Remove the rubber seal from around the
headlight (Figure 40). Discard the headlight.
Figure 40
1. Rubber seal
2. Inside notch-align with the
notch on the headlight
2. Accessories Fuse
3. Outside notch-align with
notch in hood
4. Headlight