Auto Power Option (Ap); End Of Cycle Beeps (Ec); Closed Drawer Option (Ld); Clean/Dirty Dish Symbol (Ds) - Fisher & Paykel DishDrawer DD24D Series Service Manual

599735A
Selection of a setting affects how the electronic controller diverts supply water, how much water is
treated, and how much salt is used in regeneration, in a manner that optimises the performance of
the water softener.
Note: On an integrated DishDrawer™, when the user turns on or turns off one of the following
options, it is indicated by the red wash cycle LEDs on the secondary control panel. If an option is
turned on, then all the LEDs turn on, and if an option is turned off, all the LEDs turn off.
4.3

Auto Power Option (AP)

The automatic power up sequence that occurs when the tub is opened can be turned on or off
using the KEYLOCK button. If the scrubbing brush symbol is showing on the LCD, then the auto
power up sequence will occur when the tub is opened. If the scrubbing brush symbol is not
showing, then the DishDrawer™ will not automatically power up when the tub is opened (and the
customer will need to push the power button each time they want to use the DishDrawer™). Push
POWER to exit when the desired setting has been selected.
4.4

End of Cycle Beeps (EC)

The six beeps that occur at the end of every cycle can be turned on or off using the KEYLOCK
button. If the scrubbing brush symbol is showing on the LCD, then the end of cycle beeps are
activated. If the scrubbing brush symbol is not showing, then the end of cycle beeps are
deactivated. Push POWER to exit when the desired setting has been selected.
4.5

Closed Drawer Option (Ld)

The closed drawer option can be turned on or off using the KEYLOCK button. If the scrubbing
brush symbol is showing on the LCD, then the closed drawer option is selected and it will keep the
DishDrawer™ locked at all times by bringing the lid down when the drawer is closed. When this
mode is selected, the customer needs to push the power button to lift the lid whenever they want to
open the drawer. When they close the drawer again the lid comes down automatically after 30
seconds and locks the tub closed. If the scrubbing brush symbol is not showing, then the closed
drawer option is deactivated. Push POWER to exit when the desired setting has been selected.
4.6

Clean/Dirty Dish Symbol (dS)

(Only displayed on prefinished models with LCD)
The clean/dirty dish symbol can be turned on or off using the KEYLOCK button. If the scrubbing
brush symbol is showing on the LCD, then the clean/dirty dish option is selected. This means the
clean/dirty dishes symbol will remain in the LCD display at the end of the cycle until the power
button is pressed to clear it. If the scrubbing brush symbol is not showing, then the clean/dirty dish
symbol will disappear when the drawer is first opened at the end of a cycle. Push POWER to exit
when the desired setting has been selected.
22