Lid - Fisher & Paykel DishDrawer DD24D Series Service Manual

599735A
8.19

Lid

1. Remove the tub assembly (refer to Section 8.6).
2. On the right-hand side of the lid, Insert a flat blade screwdriver
into the slots between the lid flange and the yoke as in Fig 1.
Twist the screwdriver while pulling down on the lid to disengage
the clip. Repeat for each clip on both yokes. Note: Do not pull
on the lid seal.
3. Pull the lid down 10mm (3/8") on one side.
4. Pull the opposite side of the lid down until it is clear of the yoke.
The high side of the lid can then be pulled to the bottom of the
yoke slots. The lid is now free to be removed from the chassis
on an angle as per Fig 2.
To reassemble.
1. Angle the lid into the chassis, ensuring the lid is the correct way
around. The word "Front" is printed on the top of the lid and
should be at the front of the product.
2. Engage the T-Rib on the high side of the lid into the bottom of
the yoke slots. Swing the opposite side of the lid up past the
yoke until it sits into the bottom of the yoke slots. Note that the
T-Ribs make the lid wider so some force is required to push
past the yoke.
3. Clip the lid into place. Start by pushing one corner of the lid up
until it clicks. Next clip the diagonal corner up.
4. The lid is now assembled and should look like fig 3 and not like
fig 4.
54
Fig 1
Fig 2
√
Fig 3
X
Fig 4