Fisher & Paykel DishDrawer DD24D Series Service Manual page 12

599735A
Component
Heater Plate 230V
Water Heater Track
Power Supply
Resistor
Heater Plate 110V
Water Heater Track
Power Supply
Resistor
Temperature Sensor
Fusible Link
Water Inlet Hose
Water pressure
Drain Hose
Power Cord
Drying Fan
Diverter Valve
Softener Assy
Brine Pump Assy
Water Softener
Lid Actuator
Hall Sensor
LCD
Specifications
230V AC
50 Ohms +/- 4 Ohms
98 Ohms +/- 7 Ohms
120V AC
24 Ohms +/- 3 Ohms
24 Ohms +/- 3 Ohms
O
12000 Ohms @ 20
O
8300 Ohms @ 30
O
3000 Ohms @ 60
O
268 – 302 C (514 – 576
1000Kpa / 145 P.S.I.
1561 mm from LHS
1344 mm from RHS
1 MPa (145 psi) max, 0.1 MPa (14.5
psi) min
1 MPa (145 psi) max, 0.03 MPa (4.3
psi) min
2011mm from LHS (79 inches)
1794 mm from RHS (71 inches)
1776 mm from LHS (69 Inches)
1559 mm from RHS (61 Inches)
24V brushless DC motor 0.27A
Approximately 2 to 3 Meg Ohms
24V DC Coil
65 +/- 10 Ohms Coil
24V DC Coil
65 +/- 10 Ohms Coil
500 grams Salt Capacity
Approximately 14 regenerations
290+/- 10ml Resin
24 V DC
Approximately 30 Ohms
4.13, and 3.43 mOhms
measured +ve in centre, -ve to outside
LCD has back light
NZ, AU, GB, EU, DK
US, TW 110V NZ/AU
O
C (68 F) Located on the heater Plate
O
C (86 F)
O
C (140 F)
O
F) Located on the heater plate
Pressure rating
Length from chassis edge
(viewed from the front)
Water softener models
Non water softener models
Length from chassis edge
(viewed from the front)
Length from chassis exit
(viewed from the front)
Polarity sensitive
Meter +ve to red wire, -ve to
black wire
5 volt rail between pins 2 & 5
12
Comments