Show Off / Showroom Wash Mode - Fisher & Paykel DishDrawer DD24D Series Service Manual

5.1.8

Show Off / Showroom Wash Mode

This mode initiates a shop show off display and wash operation demonstration.
With the DishDrawer™ powered up and turned on, the show off mode is entered by pressing and
holding the ECO and POWER buttons simultaneously for 5 seconds. Ensure that ECO is pressed
first.
The DishDrawer™ is now in the show off mode and cycles through all of the LED & LCD
segments.
Pressing the POWER button now puts the DishDrawer™ into the showroom wash mode. Before
running this mode, the tub should be filled with water until it is almost touching the underside of the
spray arm. The showroom wash is started by pushing the START/PAUSE button whereby the
following cycle is run:
• The lid is pulled down.
• The wash motor starts and runs for 4 minutes.
• The wash motor stops.
• The lid is lifted.
• The display counts down to zero throughout this cycle.
• The DishDrawer™ turns off at the end of this cycle.
The DishDrawer™ is still in the showroom wash mode however, and it can be re-run by pushing
POWER and then START/PAUSE. Once show off/showroom wash mode has been initiated, the
mains power supply must be removed to exit out.
Playing Tunes
Once in showroom mode, holding the START/PAUSE button down for 3 seconds will start a tune
playing. Pressing the START/PAUSE button again will toggle the tune between Bach and the Star
Spangled Banner. This feature is not widely known about, may not be present in all models and
may be removed in future products.
29
599735A