Option Adjustment Mode; Rinse Agent Setti; Auto Power; Water Pressure - Fisher & Paykel DS601V2I-87550 Use & Care Manual

OPTION ADJUSTMENT MODE
After using the DishDrawer, you may want to change some of the [)reset options to suit
your needs. You can change tile following settings:
,, [_tinse Agent
,, Auto Power
Water Pressure
[ o make these changes it is necessary to enter into tile Option Adjustment Mode
To Enter the Option Adjustment Mode
,, Press tile Power button to turn tile DishDrawer on.
• Press and hold tile Program and Eco Save button simultaneously for five seconds.
,, When tile buttons have been pressed correctly tile DishDrawer will give one long
beep.
• Release tile two buttons. Use tile buttons on tile primary and secondary control
panel to make your changes to the pre set options. I hese are explained below.
,, Press Power to return to tile Normal mode. Your DishDrawer will save these
changes automatically.
,, I o make fllrther changes repeat tile above steps.
Rinse Agent Setting
,, Enter tile
Option
Adjustment Mode as explained above.
,, I he current rinse agent setting is shown oil tile secondary control panel in orange
lights.
,, Press tile Program button to advance tile setting. I he options are from one to five.
For example two orange lights indicate tile rinse agent setting is set at two. Select
tile setting you require.
• Press Power button to return to tile Normal mode.
2O