Clip Rate Selection Chart - Toro 03800TE Operator's Manual

ensure satisfaction with the quality of cut. The height-of-cut
knob may be set one position on either side of the position on
the chart to account for differences in grass condition, grass
length removed, and personal preference of the superintendent.
For a cut with more grass removed but slightly more clip visi-
bility, move the height-of-cut selector knob one position higher
than specified. For a cut with less grass removed and slightly
less clip visibility, move the height-of-cut selector one position
lower than specified.
Full Speed—There may be times when it is desirable for the reels
to run at full speed regardless of the machine's traction speed.
Examples of this are vertical cutting or heavy scalping. In such
cases, the height-of-cut selector knob may be set to position "A"
which will command the machine controller to run the reels at full
speed at all times.
11-Blade Cutting Unit
Height-of-Cut Knob
Selection
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
FULL SPEED—Cutting units will always run at full speed in this position
20
CLIP RATE (REEL SPEED) SELECTION CHART
Height of Cut
FULL SPEED
9.6 mm
10.7 mm
11.7 mm
12.7 mm
13.7 mm
14.7 mm
15.7 mm
16.8 mm
17.8 mm
18.8 mm
19.8 mm
20.8 mm
21.8 mm
22.9 mm
23.9 mm
8-Blade Cutting Unit
Height-of-Cut Knob
Selection
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Height of Cut
FULL SPEED
16.0 mm
17.3 mm
18.5 mm
19.6 mm
20.8 mm
21.8 mm
22.9 mm
23.9 mm
24.9 mm
25.9 mm
26.9 mm
27.9 mm
29.0 mm
30.1 mm
31.0 mm