Table of Contents
Advertisement
REEL CONTROL LIGHT
The Reel Control light, located on the front control panel, is used to
give feedback to the operator whether the machine controller can
achieve the desired clip. If the machine is operated at a traction
speed that is too low or too high, the machine controller may not be
able to set the reel speed at the required value for the desired clip.
If this occurs, the Reel Control light will illuminate.
If the Reel Control light illuminates, it means one of the following
things:
1.
The machine is being operated at a traction speed too slow to
allow desired clip.
2.
The machine is being operated at a traction speed too fast to
allow desired clip. To correct the situation, change the traction
speed until the light goes out.
3.
A foreign object, such as a stick, piece of turf, etc. is restricting
reel rotation.
If changing the traction speed or removing the foreign object does
not cause the light to go out, and the Reel Control light remains
illuminated regardless of traction speed, then a service issue is indi-
cated. In this case, refer to the Diagnostic Display section of this
manual, check the service manual or contact your local authorized
Toro Distributor.
PUSHING OR TOWING THE MACHINE
In an emergency, the Reelmaster 6500-D can be moved by actuating
the by-pass valve in the variable displacement hydraulic pump and
pushing or towing the machine.
IMPORTANT: Do not push or tow the machine faster than 2–3
mph (3-4.8 km/hr) because internal transmission damage may
occur. The by-pass valve must be open whenever the machine is
pushed or towed.
1.
The by-pass valve is located on the top of variable displace-
ment pump (Fig. 18). Rotate the valve 90° in either direction,
to open and allow oil to by-pass internally. Because fluid is
by-passed, the machine can be moved—slowly—without dam-
aging the transmission.
2.
Close the by-pass valve before starting the engine. However,
do not exceed 7–11 Nm torque to close the valve.
or
or
Fig. 18
21
Advertisement
Table of Contents
