Table of Contents
Advertisement
Note: When backlapping, the front units all operate together, and
the rear units operate together.
1.
Position the machine on a level surface, lower the cutting units,
stop the engine, engage the parking brake, and move the
Enable/Disable switch to the Disable position.
2.
Unlock and raise the seat to expose the controls.
3.
Open the control cover and turn the height-of-cut selection
knob to position "P".
Note: Backlapping speed may be increased by moving the
height-of-cut selection knob toward to "A". Each position will
increase speed 60 rpm. After changing selector, wait 30 sec-
onds for the system to respond to the new speed target.
4.
Make initial reel-to-bedknife adjustments appropriate for back-
lapping on all cutting units that are to be backlapped.
5.
Start the engine and run it at idle speed.
DANGER: To avoid personal injury, never place your
hands or feet in the reel area while the engine is running.
Changing engine speed while backlapping may cause the
reels to stall. Never change engine speed while backlap-
ping. Only backlap at idle engine speed. Never attempt to
turn reels with your hand or foot while the engine is run-
ning.
6.
Select either the front or rear on the backlap switch to deter-
mine whether front or rear reels will be backlapped.
DANGER: To avoid personal injury, be certain that you
are clear of the cutting units before proceeding.
7.
Move the Enable/Disable switch to the Enable position. Move
the Lower Mow/Lift control forward to start back-lapping
operation on designated reels.
8.
Apply lapping compound with the long-handle brush supplied
with the machine. Never use a short-handle brush.
9.
If the reels stall or become erratic while backlapping, the reel
control light will begin to blink and the reels will turn off. If
this occurs, turn the height-of-cut. selection knob one position
closer to "A". Then, toggle the Enable/Disable switch to the
Disable position followed by the Enable position. To resume
backlapping, move the Lower Mow/Lift control lever forward.
36
Figure 50
1.
Tie rod clamps
Figure 51
1.
Fuses
IMPORTANT
USE CORRECT FUSES.
WRONG FUSES CAN CAUSE
DAMAGE TO CONTROLLER AND
VOID WARRANTY.
OPTIONAL
LIGHTS
10A
CONTROLLER
POWER (2)
15A
LEAK
DETECTOR
5A
OPEN
CONTROLLER
POWER (1)
10A
IGNITION
SWITCH
5A
CONTROLLER
POWER
10A
CONTROLLER
POWER
10A
93-7596
Advertisement
Table of Contents
