Suspended Ceiling Adjustable T-Rail Clips - Cisco Aironet 1130AG Hardware Installation Manual

Chapter 2 Installing the Access Point

Suspended Ceiling Adjustable T-Rail Clips

The accessory kit contains two suspended ceiling adjustable T-rail clips; one for standard ceiling tile
rails and the other for recessed ceiling tile rails. The clips are adjustable to accomodate three standard
T-rail widths. Each clip contains detents that are used to adjust the clip to the T-rail. Each detent contains
markings that indicate the T-rail width and the hole letter that corresponds to the correct mounting holes
on the mounting plate.
Figure 2-3
CEILING
GRID
WIDTH
1
2
The adjustable T-rail clip attaches to the mounting plate using four 6 x 32 x 1/4 inch flat head screws.
The A, B, and C holes on the T-rail clips and the mounting plate correspond to these T-rail widths:
•
•
•
OL-6226-02
Figure 2-3
T-Rail Clip Features
1
2
3
38 24 15
MM
INCH
1-1/2 15/16 9/16
A B C
2
1
T-rail locking screws
Mounting plate screw holes
(8 x 32 flat head screw)
A holes—used for 1 1/2 in (38 mm) T-rails
B holes—used for 15/16 in (24 mm) T-rails
C holes—used for 9/16 in (15 mm) T-rails
shows the details of the adjustable T-rail clips.
2
3
2
3 T-rail width adjustment detents (A, B, C)
correspond to the A, B, and C holes on the
mounting plate
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Before Beginning the Installation
2-7