Mounting The Access Point Below A Suspended Ceiling - Cisco Aironet 1130AG Hardware Installation Manual

Mounting the Access Point Below a Suspended Ceiling

Mounting the Access Point Below a Suspended Ceiling

You should review
Figure 2-7
CEILING
GRID
WIDTH
1
2
Follow these steps to mount your access point on a suspended ceiling:
Step 1 Decide where you want to mount the access point on your suspended ceiling.
Step 2 Select the appropriate adjustable T-rail clip for your suspended ceiling and open the clip to the maximum
(see
Step 3 Place the T-rail clip over the T-rail and close it (see
Tighten the two T-rail locking screws to prevent the T-rail clip from sliding along the T-rail.
Step 4
Observe the T-rail width detent letter (A, B, or C) that corresponds to the T-rail width.
Step 5
Align the corresponding (A, B, or C) holes on the mounting plate over the T-rail mounting plate holes.
Step 6
Hold the mounting plate and insert a 6 x 32 x 1/4 in. flat head screw into each of the four corresponding
Step 7
(A, B, or C) holes and tighten.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
2-12
Figure 2-7 before beginning the mounting process.
Adjustable T-Rail Clips
1
2
3
38 24 15
MM
INCH
1-1/2 15/16 9/16
A B C
2
1
T-rail locking screws
Mounting plate screw holes
Figure 2-4).
2
3
2
3 T-rail width detents (A, B, or C)
Figure 2-4) to the appropriate (A, B, or C) detent.
Chapter 2 Installing the Access Point
OL-6226-02