Before You Start; Resetting The Access Point To Default Settings; Using The Mode Button - Cisco Aironet 1130AG Hardware Installation Manual

Before You Start

Before You Start

Before you install the access point, make sure you are using a computer connected to the same network
as the access point, and obtain the following information from your network administrator:
•
•
•
•
•
•

Resetting the Access Point to Default Settings

Using the Mode Button

If you need to start over during the initial setup process, follow these steps to reset the access point to
factory default settings using the access point MODE button:
Step 1 Open the access point cover (refer to the
Disconnect power (the power jack for external power or the Ethernet cable for in-line power) from the
Step 2
access point.
Press and hold the MODE button while you reconnect power to the access point until the Ethernet LED
Step 3
turns an amber color, approximately 2 to 3 seconds, and release the button. All access point settings
return to factory defaults.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
3-2
A system name for the access point
The case-sensitive wireless service set identifiers (SSIDs) for your 802.11g and 02.11a radio
networks
If not connected to a DHCP server, a unique IP address for your access point (such as
172.17.255.115)
If the access point is not on the same subnet as your PC, a default gateway address and subnet mask
A Simple Network Management Protocol (SNMP) community name and the SNMP file attribute (if
SNMP is in use)
If you use Cisco IP Setup Utility (IPSU) to find or assign the access point IP address, the MAC
address from the label on the bottom of the access point (such as 00164625854c)
Chapter 3 Configuring the Access Point for the First Time
"Opening the Access Point Cover" section on page 2-9).
OL-6226-02