Cisco Aironet 1130AG Hardware Installation Manual page 97

Chapter 6 Troubleshooting
Perform these steps to configure your access point power settings using the browser interface:
Step 1 Obtain the access point IP address and browse to your access point.
Step 2 Perform one of these operations:
When you browse to your access point operating in low-power mode, a Warning message appears
a.
indicating that all radios are disabled due to insufficient power. Click OK to jump to the System
Power Settings located on the System Software > System Configuration page.
b. When you browse to your access point operating in full-power mode, choose System Software >
System Configuration.
Step 3 Choose one of these Power Settings options (see
If your Cisco switch supports Intelligent Power Management negotiations, choose Power
a.
Negotiation.
b. If your Cisco switch does not support Intelligent Power Management negotiations, choose
Pre-standard Compatibility.
c. If you are using a non-Cisco switch, changes to the power settings are not required.
If you are using a power injector with a Cisco switch, choose one of these Power setting options (see
Step 4
Figure
If your Cisco switch supports Intelligent Power Management negotiations, uncheck Installed on
a.
Port with MAC address.
b. If your Cisco switch does not support Intelligent Power Management, check Installed on Port with
MAC address and ensure the MAC address for your switch port is displayed in the MAC address
field. The HHHH.HHHH.HHHH indicates the MAC address contains 12 hexadecimal digits.
Note
Click Apply and a message appears indicating that you should disable pop-up blockers before
Step 5
proceeding.
Step 6 Click OK to continue. Your access point reboots and your power settings are configured in the access
point.
Note
OL-6226-02
6-2):
The MAC address field is not case-sensitive.
You might have to refresh your browser screen to obtain the latest browser page that indicates
your radios are enabled.
Figure 6-2):
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Low Power Condition
6-13