Cisco Aironet 1130AG Hardware Installation Manual page 94

Low Power Condition
Table 6-2 Using Cisco IOS Commands
Power Source
AC power module
Cisco switch that supports Intelligent Power
1
Management
Cisco switch that does not support Intelligent
1
Power Management
2
Power injector used with a Cisco switch that
supports Intelligent Power Management
2
Power injector used with a Cisco switch that
does not support Intelligent Power
1
Management
Power injector used with a non-Cisco switch
802.3af compliant non-Cisco switches
1. You should check the release notes for your Cisco power source to determine which Cisco IOS release supports Intelligent Power Management. Support
for Intelligent Power Management might not be currently available for your Cisco power source.
2. Power injector must be AIR-PWRINJ3 or AIR-PWRINJ-FIB.
3. Cisco switches that support Intelligent Power Management always configure the use of a power injector at the switch.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
6-10
Access Point
None required
no power inline negotiation prestandard source
no power inline negotiation injector
power inline negotiation prestandard source
no power inline negotiation injector
no power inline negotiation prestandard source
1
no power inline negotiation injector
no power inline negotiation prestandard source
power inline negotiation injector xxxx.xxxx.xxxx
(where xxxx.xxxx.xxxx is the MAC address of the
switch port to which the access point is connected)
Note The MAC address might be available from the
Inline Power Status message.
None required
None required
Chapter 6
Cisco IOS Commands
Troubleshooting
Cisco Switch
power inline never
power inline auto
power inline auto
3
power inline never
power inline never
–
–
OL-6226-02