Using The Web Browser Interface; Reloading The Access Point Image - Cisco Aironet 1130AG Hardware Installation Manual

Reloading the Access Point Image

Using the Web Browser Interface

Follow these steps to delete the current configuration and return all access point settings to the factory
defaults using the web browser interface.
Open your Internet browser.
Step 1
Note
Note
Step 2 Enter the access point's IP address in the browser address line and press Enter. An Enter Network
Password screen appears.
Step 3 Enter your username in the User Name field.
Step 4 Enter the access point password in the Password field and press Enter. The Summary Status page
appears.
Step 5 Click System Software and the System Software screen appears.
Click System Configuration and the System Configuration screen appears.
Step 6
Click the Reset to Defaults button.
Step 7
Note
After the access point reboots, you must reconfigure the access point by using the Web browser interface,
Step 8
the Telnet interface, or Cisco IOS commands.

Reloading the Access Point Image

If your access point has a firmware failure, you must reload the complete access point image file using
the Web browser interface or by using the MODE button. You can use the browser interface if the access
point firmware is still fully operational and you want to upgrade the firmware image. However, you can
use the MODE button when the access point has a corrupt firmware image.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
6-16
The access point web-browser interface is fully compatible with Microsoft Internet Explorer
version 6.0 on Windows 98 and 2000 platforms and with Netscape version 7.0 on Windows 98,
Windows 2000, and Solaris platforms.
When using the access point browser interface, you should disable your browser pop-up blocker.
If the access point is configured with a static IP address, the IP address does not change.
Chapter 6 Troubleshooting
OL-6226-02