Speedometer - BOMBARDIER traxter max series Operator's Manual

Table of Contents

Advertisement

1
V01A65Y
1. Gear position display
The gear position display lights up to
indicate the gear selection whenever
the ignition switch is turned on when
the transmission lever is NOT in PARK
or in NEUTRAL position (whether or
not engine is running).
If all lights flash while shifting gear,
it indicates the shifting is not com-
pleted yet. Simply wait until the shift-
ing completes or retry the shift with
the gear shift button.
If all lights flash continuously, it in-
dicates a damaged sensor (gearbox).
Although the vehicle can still be op-
erated in this condition, downshifting
may increase engine "braking". Drive
slowly. See an authorized Bombardier
ATV dealer as soon as possible.

8) Speedometer

These vehicles are equipped with an
electronic speedometer. It indicates
the speed of the vehicle either in MPH
and km/h.
The speedometer is located at the
middle of cluster and it is backlit when
the ignition switch is turned ON (ei-
ther position).
3
V01A66Y
TYPICAL
1. Speedometer
2. Display (Odometer/trip meter/hourmeter)
3. Display selection button
4. Indicator lamps
Change from One Unit to
the Other
The speedometer is factory preset in
miles but it is possible to change is
reading to kilometer.
NOTE:
plied to the speedometer, odometer
and trip meter.
Turn the ignition switch to the OFF po-
sition.
Insert a little flat screwdriver into the
slot at the bottom of the speedome-
ter. Slightly, pry the speedometer and
turn it clockwise then remove it from
steering pod.
V01A67Y
_____________________
4
The unit modification is ap-
1
2
95

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents