BOMBARDIER traxter max series Operator's Manual page 131

V01C2QY
1. Oil strainer cover
2. Oil plug
3. Coolant plug
All Models
To clean oil strainer, use a solvent then
dry with compressed air.
WARNING
Always wear eye protection and
gloves.
Reinstall oil strainer, oil collector and
oil strainer cover.
Change gasket on drain plug. Clean
gasket area on engine and drain plug
then reinstall plug. Refill engine at the
proper level with the recommended
oil. Refer to SPECIFICATIONS for ca-
pacity.
Start engine and let idle for a few min-
utes. Ensure oil filter area and drain
plug areas are not leaking.
Stop engine. Wait a while to allow oil
to flow down to crankcase then check
oil level. Refill as necessary.
Dispose of oil as per your local envi-
ronmental regulations.
Coolant Replacement
WARNING
In order to avoid potential burns,
do not remove the radiator cap or
loosen the engine drain plug if the
engine is hot.
Turn the radiator cap counterclockwise
3
and remove it.
2
On Traxter MAX CVT , remove the
skid plate under vehicle, the RH side
panel and the door in the footrest.
1
Remove the drain plug and drain the
coolant into a suitable container.
V04L1LY
TRAXTER MAX CVT — UNDER OIL
FILTER COVER
1. Cooling drain plug
NOTE:
completely.
V01C3SZ
TRAXTER MAX 5 SPEED — UNDER ENGINE
1. Cooling drain plug
Unscrew the bleeding screw on the
top of thermostat housing.
Drain the system completely and rein-
stall the drain plug.
NOTE:
lift the rear of vehicle, about 75 mm
(3 in).
Pinch hose between radiator and ther-
mostat housing with a large hose
pincher (P/N 529 032 500) or an equiv-
alent.
_____________________
1
Do not unscrew the drain plug
1
On Traxter MAX 5 SPEED ,
131