Maintenance; Engine/Transmission - BOMBARDIER traxter max series Operator's Manual

V01C3SY
TRAXTER MAX 5 SPEED
1. Oil drain plug
Allow enough time for oil to flow out
of oil filter.
Traxter MAX CVT
Remove the RH side panel then the
door in the footrest.
1
V04L1KY
1. Side panel
2. Footrest door
Unscrew the oil filter cover.
Remove the oil filter and replace with
a new filter.
NOTE:
Check the cover O-ring and
change it if necessary.
Wipe out any oil spillage on engine.
Remove skid plate.
Remove oil strainer cover and oil col-
lector, located near drain plug, then
clean oil strainer.
_____________________
130
1
2
V04C09Y
1. Oil strainer cover
2. Oil plug
Traxter MAX 5 SPEED
Carefully unscrew oil filter and as soon
as it can be removed from the engine,
turn it upright. Discard filter.
NOTE:
Be sure that the old filter
O-ring is removed.
CAUTION:
Only use Bombardier
high pressure filter or suitable
equivalent. The Bombardier filter
is specifically designed for this en-
gine. This filter does not operate at
the same pressure as other brands.
Using a non-recommended filter
may cause serious engine/trans-
mission damage. See an autho-
rized Bombardier ATV dealer.
Lubricate the O-ring on the filter with
engine oil. Install the new filter then
screw one full turn after O-ring con-
tact.
Wipe out any oil spillage on engine.
Remove skid plate.
Remove oil strainer cover and oil col-
lector, located near drain plug, then
clean oil strainer.
2
1