Indicator Lights Cluster - BOMBARDIER traxter max series Operator's Manual

On some occasions, it may be useful
or necessary to manually change the
gear selection. The electronic module
will allow the rider to override the au-
toshift mode by pressing the shift but-
ton to a lower gear or a higher gear.
The autoshift mode will be kept and
the shifting sequence will resume af-
ter shift is performed.
However, if the vehicle is used in
severe conditions, it is highly recom-
mended to use the manual mode (use
the gear shift button).
Start/Stop Switch
Located on top of the multi-function
switch. Dual function switch.
V01A63Y
1. Start/stop switch
To start engine, press and hold the
switch. Release immediately after en-
gine is started.
To stop engine, fully release throttle
lever then press the switch. It is not
necessary to hold the switch.
NOTE:
While engine can be stopped
by turning ignition key OFF, we recom-
mend the engine be stopped by press-
ing the start/stop switch.
______________________
94
1
Headlamp Dimmer Switch
Located under the electric gear shift
button. Toggle type switch. It allows
selection of headlamp intensity.
V01I070
1. Headlamp dimmer switch
7) Indicator Lights
Cluster
Traxter MAX 5 SPEED
NOTE:
When first turning switch to
ON (either position), all indicator lights
will turn on for a brief moment. This
validates their operation. Thereafter,
only the lights that are activated will
remain .
NOTE:
Temperature light stay on un-
til the engine runs.
If all lights flash, it indicates a particu-
lar malfunction of the transmission or
the electrical system. See an autho-
rized Bombardier ATV dealer as soon
as possible.
Gear Position Display
Located on left side of cluster. It lights
up to indicate the gear position when-
ever the ignition switch is turned
on when the transmission lever is
NOT in PARK or in NEUTRAL position
(whether or not engine is running).
1