Power Connector; Remove The Optical Drive; Remove The Keyboard/Top Cover From The Base Enclosure - HP ENVY 17 Maintenance And Service Manual

Power connector

Description
For use only on select HP ENVY 15 Computer Notebooks models
For use only on select HP ENVY 17 Computer Notebooks models
Before removing the power connector, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the keyboard/top cover from the base enclosure (see
7. Remove the WLAN module (see
8. Remove the subwoofer (see
9. Remove the system board (see
Remove the power connector cable:
1. Release the metal clip to disconnect the power connector cable (1) from the system board.
2. Disengage the cable from the clips (2).
3. Release the clips (3), and then remove the power connector cable (4).
Reverse this procedure to install the power connector cable and bracket.
72 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 32),
Optical drive on page
WLAN module on page
Subwoofer on page 55).
System board on page
33).
Keyboard/top cover on page
50).
58).
Spare part number
762507-001
763699-001
36).