Power Button Board - HP ENVY 17 Maintenance And Service Manual

Power button board

Description
Power button board (includes cable) For use only on HP ENVY 15 Notebook PC computer models
Power button board (includes cable) For use only on HP ENVY 17 Notebook PC computer models
Before removing the Power button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the keyboard/top cover from the base enclosure (see
7. Remove the WLAN module (see
8. Remove the subwoofer (see
9. Remove the system board (see
Remove the Power button board and cable:
1. Turn the top cover upside down, with the back edge toward you.
2. Remove the two Phillips screws securing the Power button board to the base enclosure (1).
3. Remove the Power button board (2).
Reverse this procedure to install the Power button board.
76 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 32),
Optical drive on page
WLAN module on page
Subwoofer on page 55).
System board on page
33).
Keyboard/top cover on page
50).
58).
Spare part number
762496-001
763708-001
36).