Periodic Maintenance Chart - BOMBARDIER Outlander 400 Operator's Manual

A: ADJUST
C: CLEAN
I: INSPECT
L: LUBRICATE
R: REPLACE
T: PROCEED WITH TASK
PART/TASK
ELECTRICAL
Spark plug %
Battery connections
Wiring harnesses, cables and
lines
Condition of ignition switch, start
button and engine stop switch !
Condition of lighting system
(HI/LO intensity, brake lamp,
headlamp aiming, etc.) !
Winch
DRIVE TRAIN
Drive shaft boots and
protector's !
Drive shaft joints
Rear propeller shaft joint
Wheel bearing condition
Front/rear differentials (oil level,
seals and vents)
STEERING
Handlebar fasteners
Throttle/housing/cable
condition !
Choke condition !
Steering system (column,
bearing, etc.)
Tie rod ends
Wheel nuts/studs
Tires pressure and wear !
Front wheels alignment

PERIODIC MAINTENANCE CHART

INITIAL INSPECTION 10 H OR 30 DAYS OR 300 KM (185 mi)
(To be performed by an authorized Bombardier BRP ATV dealer. The
initial maintenance is very important and must not be neglected.)
T R
I I
I I
I I
I I
Refer to ATV Winch Operator's
Manual
I I
I
I L
$
I
I I
I
I, L I, L
I I
I I
$
I
I I
EVERY RIDE
I I
25 H OR 750 KM (470 mi)
50 H OR 1500 KM (930 mi)
100 H OR 1 YEAR OR 3000 KM (1865 mi)
200 H OR 2 YEARS OR 6000 KM
(3730 mi)
CUSTOMER
CUSTOMER
DEALER
(2) Pre-ride inspection item.
CUSTOMER
(5) Make sure the spark plug
CUSTOMER
CUSTOMER
CUSTOMER
(2) Pre-ride inspection item.
DEALER
(4) More often under severe
DEALER
CUSTOMER
R DEALER
DEALER
CUSTOMER
CUSTOMER
(2) Pre-ride inspection item.
(4) More often under severe
DEALER
DEALER
CUSTOMER
CUSTOMER
DEALER
TO BE PERFORMED
BY
LEGEND
is correctly gapped.
use such dusty area,
sand, snow, wet or
muddy conditions.
use such dusty area,
sand, snow, wet or
muddy conditions.
103