Equipment Identification; Section 2 System: Introduction; How To Use This Manual; Receipt Of Equipment - ESAB A120 Operating Manual

SECTION 2 SYSTEM:
INTRODUCTION
2.01

How To Use This Manual

This Owner's Manual applies to just specification or part
numbers listed on page i.
To ensure safe operation, read the entire manual, in-
cluding the chapter on safety instructions and warnings.
Throughout this manual, the words WARNING, CAU-
TION, DANGER and NOTE may appear. Pay par-
ticular attention to the information provided under these
headings. These special annotations are easily recog-
nized as follows:
NOTE!
An operation, procedure, or back-
ground information which requires
additional emphasis or is helpful in
efficient operation of the system.
CAUTION
!
A procedure which, if not properly
followed, may cause damage to the
equipment.
WARNING
!
A procedure which, if not properly
followed, may cause injury to the
operator or others in the operating
area.
WARNING
Gives information regarding possible
electrical shock injury. Warnings
will be enclosed in a box such as
this.
DANGER
!
Means immediate hazards which, if
not avoided, will result in immediate,
serious personal injury or loss of life.
Additional copies of this manual may be purchased by
contacting ESAB at the address and phone number in
your area listed on back cover of this manual. Include
the Owner's Manual number and equipment identifica-
tion numbers.
Electronic copies of this manual can also be downloaded
at no charge in Acrobat PDF format by going to the ESAB
web site listed below
http://www.esab.eu
0-5430
2.02 Equipment Identification
The unit's identification number (specification or part
number), model, and serial number usually appear on
a data tag attached to the rear panel. Equipment which
does not have a data tag such as torch and cable as-
semblies are identified only by the specification or part
number printed on loosely attached card or the shipping
container. Record these numbers on the bottom of page
i for future reference.
2.03

Receipt Of Equipment

When you receive the equipment, check it against the
invoice to make sure it is complete and inspect the
equipment for possible damage due to shipping. If there
is any damage, notify the carrier immediately to file a
claim. Furnish complete information concerning dam-
age claims or shipping errors to the location in your area
listed in the inside back cover of this manual.
Include all equipment identification numbers as described
above along with a full description of the parts in error.
Move the equipment to the installation site before
un-crating the unit. Use care to avoid damaging the
equipment when using bars, hammers, etc., to un-crate
the unit.
INTRODUCTION
CUTMASTER A120
2-1