Section 2 System: Introduction; How To Use This Manual; Equipment Identification; Receipt Of Equipment - ESAB Cutmaster 40 Operating Manual

SECTION 2 SYSTEM:
INTRODUCTION

2.01 How To Use This Manual

This Owner's Manual applies to just specification or
part numbers listed on page i.
To ensure safe operation, read the entire manual,
including the chapter on safety instructions and warn-
ings.
Throughout this manual, the words WARNING,
CAUTION, DANGER and NOTE may appear. Pay
particular attention to the information provided under
these headings. These special annotations are easily
recognized as follows:
NOTE!
An operation, procedure, or back-
ground information which requires
additional emphasis or is helpful in
efficient operation of the system.
CAUTION
!
A procedure which, if not properly
followed, may cause damage to the
equipment.
WARNING
!
A procedure which, if not properly
followed, may cause injury to the
operator or others in the operating
area.
WARNING
Gives information regarding possible
electrical shock injury. Warnings
will be enclosed in a box such as
this.
DANGER
!
Means immediate hazards which, if
not avoided, will result in immediate,
serious personal injury or loss of life.
Additional copies of this manual may be purchased by
contacting ESAB at the address and phone number in
your area listed on back cover of this manual. Include
the Owner's Manual number and equipment identifica-
tion numbers.
Electronic copies of this manual can also be down-
loaded at no charge in Acrobat PDF format by going to
the ESAB web site listed below
http://www.esab.eu
300X5394

2.02 Equipment Identification

The unit's identification number (specification or part
number), model, and serial number usually appear
on a data tag attached to the rear panel. Equipment
which does not have a data tag such as torch and ca-
ble assemblies are identified only by the specification
or part number printed on loosely attached card or the
shipping container. Record these numbers on the bot-
tom of page i for future reference.

2.03 Receipt Of Equipment

When you receive the equipment, check it against the
invoice to make sure it is complete and inspect the
equipment for possible damage due to shipping. If
there is any damage, notify the carrier immediately to
file a claim. Furnish complete information concern-
ing damage claims or shipping errors to the location
in your area listed in the inside back cover of this
manual.
Include all equipment identification numbers as de-
scribed above along with a full description of the parts
in error.
Move the equipment to the installation site before
un-crating the unit. Use care to avoid damaging the
equipment when using bars, hammers, etc., to un-
crate the unit.
2-1
ESAB CUTMASTER 40
INTRODUCTION