Table of Contents
Advertisement
1.01 How to Use this Manual
To ensure safe operation, read the entire manual, including the chapter on safety instructions and
warnings.
Throughout this manual, the words WARNING, CAUTION, and NOTE may appear. Pay particular
attention to the information provided under these headings. These special annotations are easily
recognized as follows:
NOTE!
An operation, procedure, or background information which requires
additional emphasis or is helpful in efficient operation of the system.
CAUTION
!
A procedure which, if not properly followed, may cause damage to the
equipment.
WARNING
!
A procedure which, if not properly followed, may cause injury to the
operator or others in the operating area.
WARNING
Gives information regarding possible electrical shock injury. Warnings
will be enclosed in a box such as this.
1.02 Receipt of Equipment
When you receive the equipment, check it against the invoice to make sure it is complete and
inspect the equipment for possible damage due to shipping. If there is any damage, notify the carrier
immediately to file a claim. Furnish complete information concerning damage claims or shipping
errors to the location in your area, listed on the back cover of this manual. Include a full description
of the parts in error.
If you want additional or replacement copies of this manual, please contact Arcair at the address
and phone number in your area listed on the inside back cover of this manual. Include the Manual
number (Page i).
1.03 Description
Arcair
SLICE
systems can cut, burn or pierce almost any metallic, non-metallic or composite
®
®
material. The SLICE exothermic torch cuts right through hard-to-cut materials such as mild, stainless
and alloy steels, cast iron, aluminum, magnesium and other non-ferrous metals, slag and refractory
materials, and concrete or brick.
89250840
SECTION 1: INTRODUCTION
SLICE EXOTHERMIC CUTTING EQUIPMENT
1
Advertisement
Table of Contents
