Changing The Turn Signal Bulb (All Exc-F Models); Changing The Speedometer Battery - KTM 250 EXC-F Owner's Manual

15 ELECTRICAL SYSTEM
15.11 Changing the turn signal bulb (All EXC‑F models)
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
15.12

Changing the speedometer battery

Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser
–
Lightly squeeze orange cap
–
Press the turn signal bulb carefully into the socket, turn it counterclockwise by
about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
Turn signal (R10W / socket BA15s) (
–
Mount the orange cap.
–
Position the diffuser.
–
Insert the screw and first turn it counterclockwise until it engages in the thread.
Tighten the screw slightly.
101722-10
Finishing work
–
Check that the turn signal system is functioning properly.
Preparatory work
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Pull the speedometer upward out of the holder.
K00122-10
–
Using a coin, turn protection cap
–
Remove speedometer battery
–
Insert the new battery with the label facing upward.
Speedometer battery (CR 2430) (
–
Check the O-ring of the protection cap for correct seating.
K00123-10
 .

in the area of the holding lugs and take it off.
p. 120)

.

all the way counterclockwise and remove it.

.
p. 120)
p. 95)
98