12
SERVICE WORK ON THE CHASSIS
–
Make sure that the throttle cable or other cables or are not trapped or damaged.
(EXC‑F Six Days)
–
Position the fuel tank and fit the two spoilers to the sides between the radiator
and radiator shield.
–
Make sure that the throttle cable or other cables or are not trapped or damaged.
–
Mount the fuel tank breather.
–
Mount and tighten screw
Guideline
Remaining screws, chassis
K00104-11
(EXC‑F EU/AU/BR)
–
Position the collar bushings and horn, and mount and tighten screws
Guideline
Remaining screws, chassis
–
Connect the connector of the horn.
K00103-11
(EXC‑F Six Days)
–
Position collar bushings between the spoiler and radiator shield.
–
Position the horn, and fit and tighten screws
Guideline
Remaining screws, chassis
–
Connect the connector of the horn.
M01023-11
(XCF‑W)
–
Position the collar bushings, and mount and tighten screws
Guideline
Remaining screws, chassis
K00146-11
–
Plug in connector
–
Remove the wash cap set.
–
Thoroughly clean the plug-in connection of the fuel line using compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the fuel
line clogs the injection valve.
–
Lubricate the O-ring and connect plug-in connection
M01007-10
Info
Route the cable and fuel line at a safe distance from the exhaust system.
Finishing work
–
Mount the seat. (
with the rubber bushing.
M6
M6
M6
M6
of the fuel pump.
p. 62)
10 Nm (7.4 lbf ft)
10 Nm
(7.4 lbf ft)
with washers.
10 Nm
(7.4 lbf ft)
.
10 Nm
(7.4 lbf ft)
of the fuel line.
70
.