KTM 250 EXC-F Owner's Manual page 50

11 TUNING THE CHASSIS
(All EXC‑F models)
–
Remove screws
lay it to one side.
–
Remove screws
–
Place the handlebar supports in the required position. Mount and tighten
screws
Guideline
Screw, handlebar holder
–
Position the handlebar.
M00987-11
–
Position the handlebar clamps. Mount screws
Guideline
Screw, handlebar clamp
(XCF‑W)
–
Remove screws
lay it to one side.
–
Remove screws
–
Place the handlebar supports in the required position. Mount and tighten
screws
Guideline
Screw, handlebar holder
–
Position the handlebar.
M00993-11
–
Position the handlebar clamps. Mount screws
Guideline
Screw, handlebar clamp

. Take off the handlebar clamps. Remove the handlebar and
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.

. Take off the handlebar supports.

.
M10
Info
Position the left and right handlebar supports evenly.
Info
Make sure the cables and wiring are positioned correctly.
Info
Make sure the gap widths are even.

. Take off the handlebar clamps. Remove the handlebar and
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.

. Take off the handlebar supports.

.
M10
Info
Position the left and right handlebar supports evenly.
Info
Make sure the cables and wiring are positioned correctly.
Info
Make sure the gap widths are even.
40 Nm Loctite ®
(29.5 lbf ft)

and tighten evenly.
M8 20 Nm
(14.8 lbf ft)
40 Nm Loctite ®
(29.5 lbf ft)

and tighten evenly.
M8 20 Nm
(14.8 lbf ft)
48
243™
243™