Changing The Headlight Bulb; Changing The Turn Signal Bulb (All Exc-F Models) - KTM 350 EXC-F Owner's Manual

15 ELECTRICAL SYSTEM
15.8

Changing the headlight bulb

Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
15.9 Changing the turn signal bulb (All EXC‑F models)
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
Preparatory work
–
Remove the headlight mask with the headlight. (
Main work
–
Turn protection cap
all the way and remove it.
–
Pull bulb socket
B01562-10
–
Pull out headlight bulb
–
Insert the new headlight bulb.
Headlight (HS1 / socket PX43t) (
–
Insert the protection cap with the bulb socket into the reflector and turn it clock-
wise all the way.
Info
Ensure that O-ring
B01563-10
–
Insert the bulb socket of the parking light into the reflector.
Finishing work
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser
–
Lightly squeeze orange cap
–
Press the turn signal bulb carefully into the socket, turn it counterclockwise by
about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
Turn signal (R10W / socket BA15s) (
–
Mount the orange cap.
–
Position the diffuser.
–
Insert the screw and first turn it counterclockwise until it engages in the thread.
Tighten the screw slightly.
101722-10

together with the underlying bulb socket counterclockwise

of the parking light out of the reflector.

.
p. 116)

is seated properly.
p. 95)

.

in the area of the holding lugs and take it off.
p. 116)
p. 92)
p. 93)
94