KTM 250 EXC-F Owner's Manual page 60

12 SERVICE WORK ON THE CHASSIS
–
Position the fork legs.
Bleeder screws
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
K00145-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
K00141-10
–
Tighten screw
Guideline
Screw, top steering head
K00142-10
–
Tighten screw
Guideline
Screw, top steering stem
K00142-11
–
Tighten screws
Guideline
Screw, top triple clamp
–
Secure the wiring harness with cable holder
K00141-11
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount cable binder.
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
K00088-11

are positioned toward the front.

.

.

.

.
M8
M8 15 Nm
(11.1 lbf ft)
M20x1.5 12 Nm (8.9 lbf ft)
M8 20 Nm
(14.8 lbf ft)
M8 20 Nm
(14.8 lbf ft)

.

.
25 Nm Loctite
(18.4 lbf ft)
58
® 243™

.