Toyota 1PZ Repair Manual page 211

FU-72 FUEL SYSTEM Injection Pump
(I) (12 V type)
Apply approx. 6 volts of DC power to the fuel cut
solenoid.
(m) (24 V type)
Apply approx. 12 volts of DC power to the fuel cut
solenoid.
NOTICE:
• When applying voltage to the solenoid, position the
battery as far away from the solenoid as possible so
that a spark does not occur.
• When connecting the battery cable, connect the
solenoid side first.
(n) The pressure for feeding fuel to the injection pump
should be 0.2 kg/cm
temperature for pump testing should be 40-45°C
(104-113°F).
(o) Install an angle gauge to the stand and set it to the
adjusting lever.
(p) Secure the adjusting lever fully on the maximum
speed side.
2
(2.8 psi, 20 kPa). The fuel