Toyota 1PZ Repair Manual page 168

FUEL SYSTEM Injection Pump
(c) Before removing the injection pump, check if the
period lines are aligned.
If not, place new matchmarks for reinstallation.
(d) Remove the two nuts holding the injection pump to
the timing gear case.
(e) Using SST, remove the injection pump.
SST 09213-60017 (09213-00020, 09213-00030,
09213-00060) and 09950-20017
NOTICE:
• Tighten the two bolts more than 8 mm (0.31 in.).
• Set SST so that it is balanced.
• Do not hold or carry the injection pump by the
adjusting lever.
• Do not put the injection pump (with HAC, or for the
1 HD-T) at an angle more than 45° from the horizon-
tal.
(f) Remove the cylinder block insulator (1 PZ and 1 HZ
(M/T) for Europe).
(g) Remove the O-ring from the injection pump.
FU-29