See The Time Of Day; Activate Backlight; Night Mode Function; Pause/Stop A Training Session - Polar Electro A300 User Manual

Hide thumbs Also See for A300:

Table of Contents

You can't lock zones during a heart rate guided phased training session you've created in the Flow web

service and started in your A300. If you have set the upper and lower heart rate limits for each phase, your

A300 will notify if you are outside the limits.

SEE THE TIME OF DAY

Bring your A300 close to your heart rate sensor to see the time of day during training. This function is called

HeartTouch. HeartTouch works with Polar heart rate sensors using GymLink technology, for example Polar

H7.

Press the LIGHT button to activate backlight during training. The backlight stays on for a couple of seconds

and turns off automatically.

Your A300 has a night mode function. If you press the LIGHT button once during pre-training mode, training

recording mode or pause mode, the backlight will be activated every time you press any of the buttons during

the training session. The display will also light up if a message is displayed. Night mode will be switched off

when you finish the training recording.

If you stop your session after pausing, the time elapsed after pausing is not included in the total training

time.

1. To pause a training session, press the BACK button.

played. To continue your training session, press START.

2. To stop a training session, press and hold the BACK button for three seconds

during training recording or in pause mode until

Recording ended

Recording paused

is dis-

is displayed.

Table of Contents